Our Products
  Product Development
  Production
  Test Prototypes
  Demo Prototypes

You are here: Products / Test Prototypes

Test Prototypes

We show a few specific examples for prototypes produced for internal R&D purposes.


Prototype CS90v1

Specifications:

  • worm gear setup
  • gearing ratio 1:50
  • contact factor 14
  • ball diameter 4 mm
  • eliminated back-lash
  • steel

The assembly drawing is as follows.

csigahajtas_1_50


This is the photo below of the entire gear assembled.

DSC01370


This is a video clip of the gear in motion (click the Play button to view):





Prototype KT45v1

Specifications:

  • non-intersecting shaft axes of the angle of 45 degrees
  • gearing ratio 1:10
  • contact factor 22
  • ball diameter 4 mm
  • eliminated back-lash
  • steel

A principal assembly drawing and a blow-up of the rollers in coupling are shown below.

prototipus_kitero_teng

a_prototipus_kitero_teng2

These below are the photos of the two main parts under machining.

csiga 016

csigakerek 006

These below are the photos of the two main parts finished and the entire gear assembled.

DSC00197

DSC00201


This is a video clip of the gear in motion (click the Play button to view):



Prototype KT00v1

Specifications:

  • parallel shaft axes
  • gearing ratio 23:26
  • contact fator 8
  • ball diameter 4 mm
  • same direction of rotation
  • eliminated back-lash
  • aluminium

A principal assembly drawing is shown below.

parh_tengelyek_26_23

This below is the photo of the two main parts finished and the entire gear assembled.

DSC00203